Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFast, Reliable Air Duct Cleaning Across Arlington
Air duct cleaning in Arlington typically runs $320-$680 for a full residential system, with most jobs completed in a single visit. We dispatch crews daily from our Dallas-Fort Worth office to Arlington neighborhoods, and we quote a written price before any work starts. Call (682) 297-4068 for a free estimate.
We’ve worked Arlington’s housing stock since 2013, and it’s unlike most of North Texas. The city built out almost entirely between 1965 and 1995 as a bedroom community between Dallas and Fort Worth, leaving an unusually dense concentration of slab-on-grade tract homes whose ductwork runs through unconditioned attics now 30-55 years old. Those attics routinely exceed 150°F through a six-plus-month cooling season. The original fiberglass duct board and early flex-duct systems are degrading, sagging, and shedding insulation fibers into the airstream at a rate that outpaces virtually anywhere in the region. For Arlington homeowners, thorough duct cleaning isn’t an occasional upgrade. It’s near-universal maintenance.
Why CleanRun Air Duct Cleaning Irving Is Arlington’s Preferred Air Duct Cleaning Company
CleanRun is independently owned and operated under the Haven Standard, established in 2013, and has served more than 52,000 homes with one non-negotiable practice: a written price before any work starts, every time. Our Air Duct Cleaning team photographs every duct run before and after, so Arlington homeowners see the difference between real work and vacuum noise.
Our crews know the east-side corridors along Arkansas Lane and Collins Street, where 1970s and 1980s ranches dominate and attic duct failure is routine. We don’t send technicians to “clean” a collapsed flex run that needs replacement. We document what we find, explain it in plain language, and put the scope and price in writing before touching a panel.
Every technician is background-checked, uniformed, and identified by name before arrival under Haven Standard Clause 3: Verified Crews. The 365-Day Done Right Promise backs every job in writing, not as a policy subject to manager approval. And if you have a competitor’s written estimate, we provide a Free Second Opinion at no cost, with our number beside theirs.
Our Air Duct Cleaning Services in Arlington
Residential Duct Cleaning
Most Arlington homes we service are single-family ranches and two-stories built between 1963 and 1993, almost universally on slab foundations with all supply and return ductwork routed through unconditioned attic spaces. These systems, typically original duct board trunks with flex-duct branches, are well past their design life. Our residential cleaning starts with a video inspection of the trunk lines, then negative-pressure extraction with HEPA filtration to capture dislodged debris without redistributing it through your living space. We agitate the duct board trunk to dislodge decades of accumulation, then photograph every run before we leave.
Commercial Duct Cleaning
Arlington’s commercial base includes retail along Interstate 20, medical offices near Texas Health Arlington Memorial, and multi-tenant buildings in the growing Entertainment District corridor. These systems see higher cycling rates and often lack maintenance records. We quote commercial work by the system, not by the vent, with a written scope that specifies which air handlers, trunk lines, and branch runs are included. Our equipment roster includes Abatement Technologies and Nikro commercial-grade negative-air machines sized for larger plenums.
Supply Duct Cleaning
Supply ducts carry conditioned air to your registers, and in Arlington’s older homes, they’re where we find the most visible failure. The flex-duct branches off the main trunk often sag where straps have failed in decades of attic heat, creating low points where debris collects and moisture can condense. We inspect each supply branch with a camera before cleaning, because a collapsed or disconnected run needs replacement, not agitation. Our crews carry replacement flex duct and collars on every truck so we can seal the system properly while we’re in the attic.
Return Duct Cleaning
Return ducts pull air back to the air handler, and in Arlington’s slab homes, they’re often the dirtiest runs because they draw from every room through undersized or poorly sealed return plenums. We see original duct board return trunks with foil-facing delamination so severe the fiberglass core is exposed, shedding fibers directly into the airstream. Cleaning a degraded return trunk without addressing the delamination is temporary at best. We document the condition, quote replacement or sealing if needed, and never treat a failing system as merely dirty.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterTrusted Brands We Service in Arlington
CleanRun crews operate professional-grade equipment from trade-recognized brands customers can verify independently: Rotobrush agitation systems, Nikro and Abatement Technologies negative-air machines, and Honeywell and Aprilaire filtration components. We don’t use shop vacs with brush attachments. The equipment matters because Arlington’s 30-55-year-old duct systems require controlled negative pressure to prevent fiber release during cleaning. When we recommend a MERV-rated filter upgrade after cleaning, it’s sized to the system and sourced from Honeywell or Aprilaire, not a generic box-store replacement.
Common Air Duct Cleaning Problems We See in Arlington Homes
- Collapsed flex-duct runs in east-side neighborhoods. Our tech pulled a collapsed flex run in a 1978 ranch off Arkansas Lane after the homeowner reported glass-fiber grit on the registers. The foil jacket had cracked and the batting had folded inward, partially choking airflow. We set up negative pressure with HEPA filtration, agitated the duct board trunk to dislodge decades of accumulation, then replaced the failed branch and sealed the collar joints before a camera inspection confirmed a clear, source-removed system.
- Cleaning only the visible run near the air handler. Some providers never reach the crushed or disconnected flex branches buried in the 150°F+ attic, the sections actually shedding fiberglass into supply and return ducts. A partial clean leaves the problem source intact.
- Skipped camera inspection of original duct board trunks. Without looking, foil-facing delamination and joint separation at flex collars go undiagnosed. The system re-contaminates within a season because the failure mode was never addressed.
- Treating a collapsed flex run as cleanable. When the batting has already folded inward and partially blocked airflow, that run needs replacement, not agitation. Cleaning alone leaves the lint pathway and fiber shed in place.
Pricing for Air Duct Cleaning in Arlington, TX
A typical residential duct cleaning in Arlington runs $320-$680 for a full system, depending on the number of duct runs, the condition of the trunk lines, and whether we find failures requiring repair or replacement. A collapsed flex-duct branch replacement adds $180-$340 per run, including sealing and camera verification. Commercial systems start around $850 and scale with air handler count and plenum access.
Every quote is written and agreed before work starts under Haven Standard Clause 1. No per-vent pricing. No teaser rates that balloon once the truck is in your driveway. We photograph every run before and after, and you receive the photo record as a standard deliverable. Call (682) 297-4068 for an exact quote. Estimates are free.
We Also Serve Cities Near Arlington
CleanRun crews work throughout the Dallas-Fort Worth metro area, with daily routes to Arlington and surrounding communities including Mansfield, Grand Prairie, Haltom City, and North Richland Hills. Scheduling and dispatch are coordinated from our Dallas-Fort Worth office.
Serving Arlington, TX - Our Local Coverage Area
We’re based in the Arlington area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Air Duct Cleaning in Arlington
Arlington’s near-total build-out between 1965 and 1995 left the city with one of the densest concentrations of slab-on-grade tract homes whose original duct board trunks and early flex-duct branches now sit in attics that top 150°F for a six-month cooling season. That extreme, sustained heat degrades fiberglass and cracks foil jackets at a rate that turns air duct cleaning from an occasional upgrade into near-universal maintenance. Homes in cooler climates or with newer duct materials simply don’t experience the same accelerated breakdown. Call (682) 297-4068 if you’re seeing white or gray fiber accumulation on registers.
We camera-inspect every run before quoting. A cleanable run has intact foil facing, no collapsed batting, and secure collar joints. A run needing replacement shows cracked foil, inward-folded fiberglass blocking airflow, or disconnection at the trunk. We show you the camera feed and explain which category each run falls into before any price is written. Call (682) 297-4068 to schedule an inspection.
A full system clean covers every supply and return duct run, the main trunk lines, the plenum connections at the air handler, and the register boots where ducts meet your ceiling or wall vents. On older Arlington homes, we also inspect and document the condition of the duct board trunk and flex-duct collars, because original materials this age often need sealing or replacement beyond cleaning alone. The photo record shows every stage. Call (682) 297-4068 for a written scope specific to your home.
Yes. North Texas is one of the worst regions in the country for cedar and juniper pollen from December through February and oak pollen in spring. That allergen load cycles through aging, leaky duct systems at exceptionally high volume. Cleaning before peak season removes accumulated debris that would otherwise trap and redistribute pollen; sealing duct failures afterward prevents reinfiltration from the attic. Many Arlington homeowners schedule in late fall or early winter for this reason. Call (682) 297-4068 to discuss timing for your system.
A properly rated MERV filter captures the fine particulate that degraded duct systems shed between cleanings, reducing the recontamination rate and protecting the coil and blower from debris that bypasses a cheap fiberglass panel. On Arlington’s 30-55-year-old systems, where some fiber release is inevitable until full replacement, the right filter is a practical intermediate step. We specify Honeywell or Aprilaire filters sized to your system’s airflow capacity, never a one-size-fits-all upgrade that restricts airflow and strains the blower. Call (682) 297-4068 to discuss filter options with your cleaning quote.
Written by Tomas Reyes, Owner at CleanRun Duct Repair & Cleaning, serving Arlington since 2013.